Restoration of a CJ-3A
Page 2
(follows page 1)


After much sanding, welding ant painting, new break lines, springs equalized, chassis was done
.


Dual brake cylinder installed


Rebuilt engine (1950 flathead Willys) and starter ready to be set on rebuilt chassis.


Engine on chassis - 11"brakes (off a CJ5) in front, 9" on rear, new brake lines and cylinders all over.


the cut out CJ-3B cowl to be set on the CJ-3A lower frame with steering column cut-out.


Cowl in place, the work started on the body witl 1,5 mm (18 gauge) galvanized steel plate


weld, adjust, weld...


until body is ready to be primed. Finaly...

CONTINUED PAGE 3 (THE FINISHED JEEP)